Description
Five horsepower Baldor electric motors deliver high industrial torque inside the Diamond Products CC515MXL2E1 Masonry Saw. This heavy table saw turns twenty-inch diamond blades to plunge eight inches deep into stone and cinder blocks. An electric induction motor powers the spindle. You must connect this saw to a dedicated 230-volt single-phase power line on site.
Diamond Products fabricates the frame and pan from heavy welded channel steel coated in industrial powder paint. A 5 HP 230V Baldor commercial induction motor draws 23 FLA, spinning the one-inch blade arbor at 2250 RPM through dual B-section V-belts. Machine weight totals 430 lbs unboxed. Physical exterior dimensions measure 52 inches long by 26 inches wide by 60 inches high on rigid steel support legs.
Key Features of Diamond Products CC515MXL2E1
Commercial masonry contractors buy Diamond Products CC515MXL2E1 table saws to cut structural block while evaluating pro equipment pricing. Masons cut cinder blocks, brick pavers, and dense granite slabs on commercial job sites without exhaust fumes or motor stall.
- Baldor 5 HP industrial motor provides continuous cutting muscle without tripping breakers.
- Twenty-inch blade guard clears eight-inch single-pass cuts through large cinder blocks.
- Cast aluminum rolling cart with steel ball bearing rollers glides under heavy stone blocks.
- Submersible electric water pump washes diamond blade segments to flush stone cuttings.
- Spring-assisted plunge cutting head allows operators to step-cut dense stone materials with control.
- Dual drive belts transfer positive rotational torque without slipping under deep aggregate cuts.
- Heavy-gauge steel water pan catches cutting mud while maintaining a rigid machine stance.
Blade Spindle Runout Load Tolerances
Bench testing on the one-inch turned and ground blade arbor confirms precision alignment under full electrical load. Arbor runout measures under 0.0010 inches TIR at the inner blade flange face. When cutting eight-inch dense concrete masonry units, the Baldor motor draws 22.1 amps with motor RPM dropping less than three percent from rated speed. Motor stator temperatures stabilize at 132 degrees Fahrenheit after three hours of steady production block cutting. The steel sliding cart tracks true without binding or table sag.
Masonry Cutting Ergonomics Maintenance Limits
Pushing heavy eight-inch concrete blocks through the blade feels smooth thanks to precision cart rollers, though plunging dense granite blocks requires steady two-hand handle leverage. The sealed switch box resists water wash downs. Do not buy this stationary table saw for road expansion joint cutting or handheld rescue work.
- Clean stone cutting mud and sediment out of the water pan every shift.
- Check drive belt tension and inspect for wear every forty operating hours.
- Grease the cutting head pivot shaft bearings through grease zerks once per month.
Factory Warranty Manifest Packaging Terms
Diamond Products covers the CC515MXL2E1 with a 1-Year commercial manufacturer warranty against defects. The factory crate contains the complete masonry saw machine, 20-inch blade guard, rolling material cart, submersible electric water pump, water pan, arbor wrench set, and the printed equipment operator instruction manual.