Description
Commercial crews with deep investments in 18V battery platforms resist switching to new voltage architectures. The Makita 36V (18V X2) LXT XCV22PTU dust extractor bridges that gap by running two 18V batteries for 36 Volt performance. It pulls 120 CFM across a 2.1-gallon canister. Continuous high-draw extraction drains both 5.0 Ah packs in under 40 minutes.
The chassis combines a high-density polyethylene canister with a shock-damped upper motor housing. Twin battery docks wire in series through a brushless motor controller to feed 36 Volts into the suction turbine. Internal wiring uses heavy silicone insulation to resist thermal hardening over extended shifts. An integrated rubber seal compresses around the HEPA cartridge base, while mechanical locks hold the dual 18V packs tight against terminal pins under heavy vibration.
Dual Battery Extractor Hardware
Two 18V LXT batteries combine to drive a powerful 36 Volt motor without dragging power cords across worksites. Bluetooth electronics synchronize tool power with vacuum activation for automated dust control.
- 36 Volt brushless motor delivers 120 CFM and 88 inches of water lift.
- AWS wireless module pairs with remote tools for automatic on-off extraction control.
- Certified HEPA filter stops 99.97 percent of particles down to 0.3 microns.
- 2.1-gallon dry debris drum empties fast through two mechanical side clasps.
- Variable suction knob tunes vacuum draw to the task.
- Twin battery fuel gauges display remaining charge levels on both 18V packs.
- Grounded antistatic hose diverts electrostatic charges away from the operator.
Telemetry Bench Dyno Evaluation
Electrical draw pulls 18.2 Amps total across both 18V battery channels under peak load conditions. Brushless motor velocity hits 20500 RPM, producing 86 inches of water lift on our test gauge. Sound output holds at 64 dBA at 1 meter on maximum speed. Upper motor housing temperatures rise by 29°F through a full 5.0 Ah battery discharge cycle, topping out at 124°F. Intake airflow measures 118 CFM through clean filters on the dyno bench.
Field Handling Maintenance Limits
Rolling on broad rear wheels, this 19-pound unit tracks behind technicians without tipping over extension cords. Do not use this dry extractor on wet concrete slurry, sump pits, or outdoor pond muck. Moisture damages the dry HEPA media, short-circuits the series battery interface, and corrodes internal motor bearings.
- Rotate battery pairs together to keep individual cell banks matched in cycle life.
- Blow fine drywall dust out of the primary filter pleats after each job.
- Check the rubber tank gasket for pinches or debris before latching the lid.
Commercial Warranty Kit Contents
Makita backs this dust extractor kit with a 3-Year warranty on the tool, dual-port charger, and 18V batteries. The boxed kit includes the vacuum unit, two 18V 5.0 Ah batteries, an 18V dual-port charger, an antistatic hose, an AWS transmitter, and two filter collection bags.
