Description
Induction-hardened alloy steel forms a heavy-duty vibrating poker head engineered to resist aggressive wear from sharp crushed rock aggregate. The Wacker Neuson IRFLEX58 Concrete Vibrator incorporates an inline electronic converter to run off standard one hundred twenty-volt outlets. It carries a sixteen-point-four foot hose. The inline converter housing catches when dragged across dense rebar mats.
The two-and-one-quarter-inch head body features case-hardened alloy steel with oil-lubricated cylindrical bearings built for high centrifugal forces. The cord-mounted electronic converter draws eight-point-five amps at one hundred twenty volts single-phase to produce twelve thousand vibrations per minute. Total tool weight equals thirty-four pounds. The abrasion-resistant rubber hose extends sixteen-point-four feet, while the input power cord provides forty-nine feet of reach. An aluminum casting houses the converter electronics.
Key Features of Wacker Neuson IRFLEX58
Commercial foundation subcontractors buy Wacker Neuson IRFLEX58 assemblies to settle stiff mass concrete pours without transporting separate frequency converters. High-frequency vibrator pricing reflects the built-in inverter system that sustains full motor frequency under heavy mud drag.
- Two-and-one-quarter-inch hardened steel head moves heavy aggregate in deep foundation footings.
- Integrated electronic inverter converts standard one hundred twenty volt current to high frequency.
- Sixteen-point-four-foot rubber hose reaches bottom zones of deep commercial retaining wall forms.
- Twelve thousand vibrations per minute eliminates rock pockets and honeycombing in low-slump concrete.
- Forty-nine foot heavy-duty power cord gives broad jobsite range without extension cords.
- Body-guard electrical interrupter protects operators from ground faults on wet slab surfaces.
- Integrated thermal cutout shuts off current if poker heads run dry outside concrete.
Mass Pour High Frequency Diagnostics
Bench dynamometer testing confirms that the head delivers twelve thousand vibrations per minute while submerged in low-slump three-inch concrete mix. Operating current draws eight-point-two amperes under maximum mud head resistance, holding constant without speed drop. Head internal bearing temperatures stabilize at one hundred forty-six degrees Fahrenheit after sixty minutes of continuous cyclic immersion. Head vibration amplitude reaches eighty-five mils in open air, producing a massive twenty-four-inch effective compaction radius in wet structural concrete pours.
Handling Rigidity Maintenance Target Limits
Managing thirty-four pounds of hose and the inline converter case requires two hands when working along elevated wall staging. The rubber-encased toggle switch functions with thick slurry-covered gloves. Do not buy this large two-and-one-quarter-inch head for narrow masonry block cells or thin decorative precast panels.
- Sponge wash concrete paste off the inline converter housing before cement cures.
- Inspect the sixteen-foot hose jacket for deep rebar cuts before every pour.
- Store the assembly loosely coiled in dry shop areas away from freezing weather.
Commercial Warranty Package Factory Manifest
Wacker Neuson protects this internal vibrator tool with a standard 1-Year commercial manufacturer warranty covering electrical and mechanical components. The factory package contains the complete IRFLEX58 vibrator with integrated inverter, forty-nine foot power cable with ground fault interrupter, and official technical service documentation.