Description
Unanchored cable pullers jump across concrete floors until the Southwire Maxis XD10 Bolt Down Kit locks the pulling carriage squarely against the foundation. High-capacity 10,000-lb cable pulls generate immense horizontal shear forces that compromise temporary chains. This heavy steel plate kit transfers line tension straight into the cured slab, stabilizing the puller throughout continuous pulls.
Industrial electrical contractors setting up substation vaults cannot risk equipment shifting while pulling multi-conductor power feeders. When a high-capacity puller shifts out of square, rope rubs violently against conduit edges, damaging jacket insulation. Anchoring this heavy mounting base keeps the capstan barrel squarely centered on the conduit run, preventing dangerous line binding.
Key Features of Southwire Maxis XD10 Bolt Down Kit
Structural floor mounting hardware secures commercial pulling equipment under maximum cable load.
- Solid 1/2-inch structural plate steel construction withstands 10,000 lbs of dynamic line shear without bending.
- Pre-cut concrete anchor slots allow fast alignment over standard 5/8-inch drop-in wedge anchors.
- High-tensile grade 8 mounting hardware clamps the puller frame flush against the floor base plate.
- Low-profile mounting footprint fits into narrow transformer corridors and tight electrical switchgear rooms.
- Durable powder-coated finish resists battery electrolyte, cutting lube, and concrete chemical degradation.
- Precision bolt hole geometry mates squarely with Southwire Maxis XD10 high-capacity pulling carriages.
Constructed from laser-cut 1/2-inch carbon plate steel, this mounting plate assembly features heavy fillet welds at all structural gusset junctions. The mounting cradle holds the Maxis XD10 puller carriage flush against the floor plane, countering both overturning moments and horizontal draw forces. Zinc-plated grade 8 fasteners lock the frame rigidly without thread galling under cyclic stress.
Anchor Shear Load Proof Metrics
Bench load testing proves this mounting weldment withstands 20,000 lbs of horizontal shear force when secured into 4,000-PSI concrete with four 5/8-inch steel anchors. When utility contractors buy Southwire Maxis XD10 Bolt Down Kit plates, pricing provides insurance against expensive conduit elbow breakages and equipment runaway. Operating on thick factory floors, this commercial cable tugger anchor plate holds true squareness across long shifts.
Field Limits Mandatory Maintenance Tasks
This bolt-down kit is engineered specifically for anchoring Southwire Maxis XD10 pullers to industrial concrete slabs. Do not install this plate on hollow concrete block floors, cracked pads, or loose structural gravel. The intense tension will rip weak fasteners from the substrate. Inspect mounting hardware regularly during heavy jobs.
- Check concrete anchor torque before each pulling shift using a calibrated torque wrench.
- Clean concrete dust and pulling lube off the steel plate surface after pulling conductors to prevent oxidation.
Manufacturer Warranty Hardware Kit Manifest
Southwire covers this bolt-down bracket kit with a 1-year limited warranty against structural weld fractures and metal failure. The heavy carton includes the welded steel floor mount plate, grade 8 mounting bolts, washers, and anchor hole drilling templates.